Lascaux Heissiegelkleber 375 (4020)

Lascaux Heissiegelkleber 375 (4020)
52,92 € *
Obsah: 1 Liter

Ceny incl. DPH plus náklady na dopravu

Připraveno k odeslání ještě dnes,
Dodací doba 1-5 pracovní dny in Deutschland **


Obnovit výběr
Dieser Artikel unterliegt einem Verkaufsverbot gemäß ChemVerbotsV.

Einordnung gemäß CLP-Verordnung:

  • 10564
Lascaux Heissiegelkleber 375 (4020)
1 l 0.96 kg 1 Liter 1
Od 1
52,92 €
Based on a mixture of ethylene-vinyl acetate copolymer, cyclohexanone resin, phthalate ester... více
Informace o produktu "Lascaux Heissiegelkleber 375 (4020)"

Based on a mixture of ethylene-vinyl acetate copolymer, cyclohexanone resin, phthalate ester of hydroabiethyl alcohol and paraffin. For screen imprints with or without intermediate layer, for paper and text images, for strip-lining. For facings, consolidation of primers and paint layers, for temporary and permanent bonding. 40% solution in toluene and boiling limit benzene 100/140.

Application Instructions:
Hot-seal adhesive (Heissiegelkleber) 375 is applied using a brush, roller or spray gun. For most of the work, Hot-Seal Adhesive 375 is slightly warmed up in a water bath and thinned approx. 2:1 to 1:1 with special boiling spirit 100/140 so that a creamy paste is obtained at room temperature. Hot-seal adhesive 375 is applied cold or warm (heat increases penetration). For spray application, it is advisable to dilute Hot-Seal Adhesive 375 with toluene in order to reduce the viscosity.

Only after complete evaporation (approx. 12-24 hours) of all solvents contained can the doubling or sealing be carried out properly. In the case of doubling, hot-seal adhesive 375 is applied either to the doubling canvas or to an intermediate carrier (e.g. polyester fleece). The completely dried hot-seal adhesive 375 layer is sealed at approx. 62-65 °C on the heating table under a slight vacuum or using an iron or a hot air gun. The heat activation can also only take place after days or weeks.

To fix and consolidate primers and paint layers, Hot-Seal Adhesive 375 is preferably diluted 1:4 with White Spirit, or, if compatibility is given, with toluene for better penetration (warm solutions also improve penetration). Sealing after complete drying at 62-65 °C and under slight pressure. Dismantling can be done either with heat or with solvents such as acetone or special boiling point petrol 100/140.

Související odkazy na "Lascaux Heissiegelkleber 375 (4020)"
Číst, psát a posoudít hodnocení... více
Zákaznické ohodnocení pro "Lascaux Heissiegelkleber 375 (4020)"
Napsat hodnocení
Hodnocení bude aktivováno po ověření.

Pole označená * jsou povinné.